Laborboard/en

-(( 666 terror Ж-)))

What does it consist of?

The board's core is a ATmega32 controller. There are 4 buttons (Port B) and 8 LEDs (Port C) connected. Additionally there is a 16Mhz quartz oscillator, a reset button and a small circuit to stabilize the supply voltage.

Getting started

You can find a list of the needed parts in this wiki -- Find the component placement specification and circuit diagram here https://roulette.das-labor.org/svnview/microcontroller/doc/Layouts/ . A lot of example code can be found in our Subversion at https://roulette.das-labor.org/svnview/microcontroller.

Step by

06.06.2005, Do: Microcontroller Workshop
14.06.2005, Fr: Microcontroller Workshop Part II
15.06.2005, Sa: Microcontroller Bastel-Samstag
08.07.2005, Fr: Microcontroller Workshop Part III
06.08.2005, Di: Microcontroller Workshop Part V (Canbus & Co)
13.09.2005, Di: Microcontroller Workshop: Borgs

14.11.2006, Di: Microcontroller Workshop
16.11.2006, Do: Microcontroller Workshop

Projects building upon the Labor Micro Board

Blinken Borgs/en
Peter's Shortcut-Tastatur
Labor automation projekt with the help of CAN Bus and LAP, the Labor Automation Protocol.

wiring standards

Setting fuses

For the controllers to work with the external quartz oscillator and to control the LEDs with all pins on Port C, you have to set the fuses correctly. ATTENTION: SETTING THE WRONG FUSES CAN BRICK YOUR CONTROLLER! The order is important, too: first set hfuse, then lfuse.

...you have been warned. ;)

 avrdude -c bsd -p m32 -t

...some kind of console upens up ...

 write hfuse 0 0xc9
 write lfuse 0 0x9f
 quit

... you should see a confirmation message

If you lack avrdude, you can also use uisp:

 uisp -dprog=bsd --wr_fuse_h=0xc9
 uisp -dprog=bsd --wr_fuse_l=0x9f

pin assignment of the programming plug

       +-----+
   GND | 0 0 | MISO
   GND | 0 0 | SCK
   GND | 0 0   RESET (inv)
   GND | 0 0 | (not assigned)
   VCC | 0 0 | MOSI
       +-----+

Links

AVR + gcc tutorial: http://www.mikrocontroller.net/articles/AVR-GCC-Tutorial
avr-libc manual: http://www.nongnu.org/avr-libc/user-manual/index.html
Toolchain install: http://www.nongnu.org/avr-libc/user-manual/install_tools.html (do not use old port/packages! avr-libc < 1.23 has bugs in malloc)
ATmega32 Data Sheet: http://www.atmel.com/dyn/resources/prod_documents/doc2503.pdf