VP5500

The Philips VP5500 is a WLAN VOIP- & Video Phone sold by KPN in the netherlands. Some of the features, such as configuration settings for the VOIP connection are usually hidden from the user, but can be revealed through a fake firmware image (description here). Thanks to this restriction the device was rendered useless when KPN decided to disconnect the VOIP services this phone was relieing on.

This article intends to collect all relevant information about the hard- & software on the telephone and to provide information to actually reuse the hardware.

Hardware

• CPU: MC9328MX21 @ 266MHz (ARM9 Core)
• FS455LF: PAL Video converter chip
• Wlan: Marvell 88w8385 (OSS driver, Datasheet)
• RAM: 64MB (2x K4S56163LF)
• Flash: 16MB
• Kamera: Chicony dc-4626.a5
• Audio Codec: TI TLV 320 AIC 12K

Pinning

Serial

VCC: 3.3V, Rate 115200 Baud

Setting the "TIN" Pin to low or pressing keys while the bootloader is waiting will redirect first Console to the serial device. Fortunately the bootloader allows editing the kernel command line, so you're able to directly "chroot" the device by setting a different initrc (sh). Type the following at the bootloader prompt:

boot root=/dev/mtdblock2 init=/bin/sh

Boot Log of the standard installation

JTAG

Pins are at the back of the circuit board.

Partitions

0x00000000-0x00014000 : "bootloader"    blob version 2.0.5-pre2
0x00014000-0x00100000 : "kernel"        /boot (?)
0x00100000-0x01ce0000 : "fs #1"         /
0x01ce0000-0x01fe0000 : "fs #2"         /user_data
0x01fe0000-0x02000000 : "fs #3"         /user_settings

Drivers & Software

Audio

• Looks as if the audio codec in use needs a proprietary driver

MPEG en/decoder

• Hantrop MPEG EN- DECODER, kernel module: hmp4e

Camera

• Patch for 2.4.X - CMOS Sensor connected via I²C

Wlan

• Libertas OSS driver

Links

• Thread where the actual reverse engineering happens
• Results will be demonstrated on the workshop root your toaster (2010/05/01)
• Hack to reveal the Config interface

Software

Bootloader (Blob)

• Project download page

Root FS & Toolchain

According to the boot log, the root fs is derived from some sample source code for the iMX21 development platform.

• process list

Kernel

Version: 2.4.20

• modules in use

Networking stuff

WPA Settings can be configured by editing the file /etc/marvell/wpa_supplicant.conf (vi is installed).

Example:

network={
 ssid="your_ssid"
 scan_ssid=1
 proto=WPA
 key_mgmt=WPA-PSK
 pairwise=TKIP
 group=TKIP
 psk="your_passphrase"
}

Configuration

For Sipgate:

SIP1 Display Name: your Name

User Name: your SIP-ID

Telephone Number: Tel.Nr.

Auth

Authentification UserName: your SIP-ID

Password: Sipgate Password

Server

SIP register address:port: sipgate.de:5060

Proxy

SIP proxy1 address:port: sipgate.de:5060

SIP2

SIP Port Listen

for UDP: 5062

for TCP: 5062

for TCP TLS: 5053

SIP Outbound needs to be empty.